Moontower Mission Control
Mission operations without the mission-control headache.
Moontower Telemetry, Command and Analytics connects hardware, telemetry, command, and mission data in one operating environment, from test to field to flight.
Moontower Mission Control is the screen your team uses to watch and command its hardware. Moonbeam carries the data. Moontower DAQ is the board on your test stand.
One record for the test and the flight.
- Monitor
See telemetry, health, and status for every asset.
- Command
Control the hardware from the screen that shows its data.
- Connect
Move the data over the link that holds.
- Test
Capture timestamped data at the stand and drive the valves.
- Integrate
Put a Raspberry Pi, a Pixhawk, or an Arduino on the same screen.
Test as you fly
You shouldn’t have to rebuild mission control for every test, every vehicle, and every new application. Today a team builds one setup for the bench, another for the field, and a third for flight, and each one starts from scratch. One mission control should run from the bench to the field to flight, with the same screens, the same commands, and the same data the whole way.
- Telemetry
One application for all your telemetry, from every board and every link.
- Command
One application for every command you send, on the bench and in flight.
- Data
All your data in one place, in sync, and there when you need it.
Architecture: three parts, one screen
Mission Control
The screen opens on the whole fleet, with each asset’s status, health, and live telemetry. You send commands from the same screen, and each command waits for a second action. Every value and every command goes into one recording. A person runs it from the screen, or an AI agent runs it through the API.
Moonbeam
Moonbeam carries telemetry down and commands up over Wi-Fi, Ethernet, LTE, 5G, and LoRa. It picks the link by range and signal quality. When a link narrows, your top-ranked channels go first, and the board sends the full-rate data when the link returns.
Moontower DAQ
A data acquisition (DAQ) kit your team assembles, soldering included. It costs $100. It reads pressures, temperatures, and digital lines at the stand, and it drives the relays for your valves. Each reading and each valve command carries a timestamp, so both line up on one time axis.
Proven
In the field
- 100,000+
Runs today on over 100,000 field-deployed devices
- 100+
Supports over 100 different missions
- 99.9%
Uptime
Trusted
By our partners
Zed has enough problems. Your telemetry shouldn't be one of them.
Specifications
| Input or output | Design value |
|---|---|
| Analog voltage | 0 to 10 V |
| Current loop | 4 to 20 mA |
| Thermocouples | Types K, J, and T, cold junction compensation on the board |
| Actuation outputs | 8, with a defined state at startup and on a fault |
| Sample rate | 1 to 100 Hz for the fleet, 1 to 10 kHz on selected channels |
| Power in | 5 to 24 V |
Table 2. Moontower DAQ design values. These are design figures, not test results.
Applications
Build. Test. Launch. Repeat.
Your setup stays on the screen when your members graduate.
Your research should be the hard part.
The grant buys the instruments. Moontower Telemetry, Command and Analytics puts them on one screen without months of wiring and scripts.
Keep your engineers on your product.
Your engineers work on the vehicle, not on stand drivers.
Your garage just got mission control.
Cameras, rockets, uncrewed boats, and remote stations report their health to one screen.
Reserve yours today
A limited edition run is coming soon. Reserve a board for a $25 refundable deposit. Pay by card. Stripe takes the deposit and the shipping address. We email a confirmation when the payment clears.
Space is hard. Make it fun.
Zero2One Space · 2026